www.boser.com.tw industrial power supply ac-dc ac-dc BPW-8310 100w ac-dc open frame atx power supply requiring 18cfm forced air cooling *input voltage: 85~264vac *input frequency: 47~63hz *input current: 3a at 115vac or 1.5a at 230vac max. *inrush current: < 30a at 115vac input or < 60a at 230vac input at 25 o c cold start *load range: with the +5v output set between 5.08~5.13v and all output at 60% rated load, while the other outputs are within the accuracy range; max. total combined output power on the +3.3v and +5v rails is 70w, with the max. load not exceeding 120w *ripple and noise: peak to peak ripple and noise is < 50mv for +5v and +3.3v outputs, 120mv for +5vsb, < 120mv for +12v, and 200mv for -12v at rated load and nominal input *line regulation: < +/-1% for rated load with a +/-10% change in input voltage *load regulation: < +/-2% for +5v, < +7~-3% for +12v, < +8~-3% for -12v, < +/-5% for +3.3v with measured output load changing within +/-40% and 60% rated load, while keeping other outputs at 60% rated load *hold up time: > 16ms at 115vac input and rated load *power on/off: turns on power supply when power on/off pin is connected to secondary gnd *efficiency: > 70% at nominal line and rated load *altitude: 10,000 feet *protection: hiccup mode against short circuit or over load conditions auto recovery when fault conditions are removed *temperature: 0~+50 o c, output power is 100w with 6cfm forced air, 120w with 18cfm forced air (operating); -40~+85 o c (storage) *connectors: ac input: molex 5273-05a withdraw 2-pin or equivalent device dc output: tb2 is molex 5273-14a or equivalent device; tb3 is molex 5045-03a or equivalent device *dimensions: 8.38 x 15.24 x 3.97 cm. tolerance at +/-0.4mm features features safety standards safety standards *safety: ul 1950 / csa 22.2 no.234 / vde en60950 *emi: fcc class b / en55022 b *ems: level 3 of iec-802, 803, 804, 805 14.44 0.4 15.24 3.8 3.3 8.38 1.4 6.85 0.765 6.85 transformer e 0v 24v use #6-32 screw protrusion limits 2.5mm x4 0.25 screw system chassis 3.87 1.5 3.15 1.5 14.14 0.55 6.78 0.8 6.78 0.8 pin 1 2 3 output pwr on/off gnd +5vsb output +5v gnd +12v +3.3v pin 1~3 4~8 9~10 11~13 -12v 14 output voltage +5v +12v -12v min. load 1a 0a 0a rated load 8a 2.5a 0.5a max. load 14a 6a 1a tolerance 4.9~5.1v 11.25~12.75v -11.25~-13v +3.3v 0a 8a 12a 3.1~3.5v +5vsb 0a 0.75a ---- 4.8~5.2v
|